Ricoh Error Codes:Paper Feed and Fusing Problems
(d) 5xx Series For Paper Feed and Fusing Problems
| |
CODE
|
POSSIBLE CAUSE
|
SC500
|
Main motor/transport motor lock/Fusing motor error
|
SC501
|
Drawer 1 lift motor malfunction
|
SC502
|
2nd or 1st tray lift motor malfunction
|
SC503
|
Drawer3(or 2nd) lift motor error
|
SC504
|
Drawer 4 or 3rd lift motor malfunction
|
SC505
|
LCC Tray malfunction
|
SC506
|
Paper tray motor lock
|
SC507
|
LCT main/feed motor lock
|
SC508
|
Rear fence drive motor
|
SC509
|
Drawer 3 LCT right fence error
|
SC510
|
LCT lower limit error
|
SC511
|
LCC motor lock
|
SC515
|
Drawer left guide drive motor error, Tandem rear fence motor error
|
SC516
|
Drawer 1 side guide motor error
|
SC520
|
Paper tray error/Duplexer jogger drive motor error
|
SC521
|
Duplexer jogger driver motor error 2
|
SC522
|
Duplex-Side fence jogger HP error
|
SC524
|
Duplex-End fence jogger HP error
|
SC530
|
Bypass feed motor lock/fusing fan motor error
|
SC531
|
Fuser/Duplexer reversing motor error
|
SC541
|
Fuser thermistor open/ Hot Roller thermistor open
|
SC542
|
Fuser Temperature warm-up error
|
SC543
|
Fuser overheat error1
|
SC544
|
Hot roller fusing lamp lower limit temperature detected
|
SC545
|
Fuser lamp overheat error 2
|
SC546
|
Fuser ready temperature malfunction
|
SC547
|
Zero cross signal malfunction/ Fusing temperature does not increase
|
SC548
|
Fusing installation error
|
SC550
|
Fusing web end
|
SC551
|
Pressure roller thermistor open
|
SC552
|
Pressure roller warm up error
|
SC553
|
Pressure roller overheat
|
SC554
|
Pressure roller low temperature abnormal
|
SC555
|
Pressure roller ready temperature abnormal
|
SC557
|
Pressure roller temperature does not increase
|
SC558
|
Zero cross signal abnormal
|
SC590
|
Exhaust/Fusing fan motor error/used toner collection motor error
|
SC591
|
Toner supply motor error
|
SC592
|
Toner bank motor error
|
SC599
|
Copy exit tray motor lock
|
Troubleshooting Tips:
| |
SC500:Too much load on the drive mechanism
| |
· Some gears or other rotating parting has been jammed.
| |
· Developing unit is over toned.
| |
· Main motor or its driving board is defective.
| |
*Before replacing motors or sensors, first check the mechanical load.
| |
SC 541:Fusing thermistor open:
| |
· Machine is plugged into low line voltage.
| |
· Fixing thermistor is defective or out of position.
| |
· Some loose connection
| |
· Power Supply board defective
| |
SC590:Left exhaust fan motor error
| |
· Loose connection of the exhaust fan motor.
| |
· Too much dust in the fan causing too much load on the motor driver.
| |
No comments:
Post a Comment